Nozzle size

Forums General Questions and Comments Nozzle size

Viewing 1 reply thread
  • Author
    Posts
    • #11398 Reply
      Sven
      Guest

      What nozzle sizes do you think work best? Very small (3mm) or something larger like 6mm?

    • #11406 Reply
      Martyn
      Keymaster

      For the top valves I prefer (and have basically settled on) barbed 6mm brass nozzles. I will modify these with bits of tube and plastic straws though. https://www.dropcontroller.com/equipment/#Nozzles

      A short while ago I did some small collisions and needed more delicate drops and used the 4mm barbed nozzles but this was a one-off. I normally find these too small for the collisions I like.

Viewing 1 reply thread
Reply To: Nozzle size
Your information: