› Forums › dropController PCBs › DropController V2 – PCB Design
- This topic has 5 replies, 2 voices, and was last updated 3 years, 10 months ago by Theo Bosters.
-
AuthorPosts
-
-
Okan ArslangirayGuest
Hi to everyone,
First of all, thank you to Martyn for sharing this wonderful project with us.
I designed a PCB for DropController V2.
I sent it to the PCB Manufacturer.
It was finally delivered and did the assembly.
And everything works properly.
Here’s some photos,
- This topic was modified 3 years, 8 months ago by Martyn.
-
Okan ArslangirayGuest
Photos do not appear in the first message.
I will try again.
-
Okan ArslangirayGuest
I couldn’t do it again.
Please right click the photos icon and choose “Open picture in new Tab”
It works for me. -
MartynKeymaster
The board looks good. I really need to learn how to make PCBs.
Until I figure out how to let people embed photos I have copied the links:
PCB Top Side
https://drive.google.com/open?id=1qf4loBsLrbX53V9E_CD_34qNWfZHcVtS
PCB Bottom Side
https://drive.google.com/open?id=1h6hlWrjYHHaxCSaSys5ter71Qj8CaZ54
Assembled
https://drive.google.com/open?id=1t-z-Z7w77iYeft3AKjCRIIGeSN1wiPC7
https://drive.google.com/open?id=1FmhpB4Qij5fx3vS1ZYe9T9L81EI_X_FM
Finished
https://drive.google.com/open?id=1boY_UW1MTm8tlgdYgFLPRNke8VEqptY7
https://drive.google.com/open?id=11FZGzLWhaZajhKAS0Ikb6ECy-L736H1U
-
Okan ArslangirayGuest
Hi Martyn,
Thank you for the corrected links.
The PCB works great. But I have only one mistake on the PCB.
The 3.5 mm stereo jack pins are opposite.
I solved the problem by soldering to the bottom side of PCB, it’s normally placed on the top side.
🙂 -
Theo BostersGuest
had the same problem with the stereo plugs, only i reconected the cable inside the stereo jack
-
-
AuthorPosts