Reply To: Dropcontroller v3 circuitry

Forums General Questions and Comments Dropcontroller v3 circuitry Reply To: Dropcontroller v3 circuitry

#8227
Gordon+Gilfether
Guest

Hello Martyn

I purchased the V3 circuit board and one or two other pieces from you recently.
I assembled the controller adding the components I already had and used a 12v input to suit the solenoids I already had (Airtac). These are getting a bit grotty now and I am planning on changing to Shako. If I change my input to 24v I assume the pot on the buck converter would have to be reset to drop the 24v to 8v. Can I do this safely on the board without affecting the other components. I can remove the Nano but everything else soldered down. Alternatively would I get the same performance with a 12v Shako as I would with the 24v.
I would be grateful if you could give me any advice on this.

Gordon Gilfether