PCB by René

Forums dropController Forum dropController PCBs PCB by René

This topic contains 2 replies, has 2 voices, and was last updated by  René 3 weeks, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2892 Reply

    Martyn
    Keymaster

    René kindly emailed the design files and photos of the dropController he built:

    The PCB files

    From René:

    These 2 Json-files can be imported in EasyEDA (https://easyeda.com/). To open the files go to folder icon in the top left corner of EasyEDA and select
    “Open” then select “EasyEDA” then select both “.json” files.

    The last time I made a PCB was 30 years ago on what is known as High School. So I am a bit rusty :-).
    I made some small changes that, I think, don’t affect the working of the PCB.

    Please have a look and look for faults, If you see room for improvements apply them.

    Some extra info on why I did design it this way:
    – H1 to H14, LED 1+2, U7 are drill holes so I can use wire to the connectors/switch

    Any questions? Please ask.

    Regards,

    René

     
    PCB by René

    PCB by René

    PCB by René

    • This topic was modified 2 months, 2 weeks ago by  Martyn.
    • This topic was modified 2 months, 2 weeks ago by  Martyn.
    • This topic was modified 2 months ago by  Martyn.
    #3160 Reply

    Wim Nijholt

    Hi René,

    I got one question for you, regarding the enclosure you are using.
    can you post some information regarding the enclosure?

    With the kindest regards,
    Wim Nijholt

    #3165 Reply

    René

    Hi Wim

    I bought the enclosure at “www.reichelt.nl” and the partnumber is RM2055M.
    The dimensions are 140 x 190 x 50 mm.

    As you can see the micro-usb cable fits, but it is tight. Turn the PCB 90 degrees clockwise.

    Regards,

    René
    The Netherlands

Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: PCB by René
Your information: